Skip to content

Module 7: Page setup, breaks, sections, and columns · Lesson 3 of 4 · 10 min

Section breaks for different page setups

You will learn to: Use section breaks to change orientation or margins for part of a document.

Helpful first: Page breaks and paragraph flow

A section is a part of a document with its own page setup: orientation, paper size, margins, columns, headers and footers. A new document has one section. To give one page a different setup — a landscape page for a wide table in a portrait report — divide the document into sections and change only the one in the middle.

A Next Page section break starts the new section on a new page; a Continuous break starts it on the same page. For a single landscape page you need two breaks, one before the wide content and one after it, and then landscape for the middle section only. A page break cannot do this, because it does not start a new section.

Word stores a section’s settings in the break at its end. When you delete a section break, the text above it joins the section below and takes on that section’s settings — so after removing a stray break, check orientation and margins again.

Worked example

Before
The whole report was turned landscape so that one appendix table would fit.
After
Next Page section breaks before and after the appendix; only the appendix section is landscape and the rest of the report is portrait.
Why it matters
Each section keeps its own setup, so the report reads normally and the table still fits.

How to do it

In Microsoft Word (Microsoft 365, Windows and Mac)

  1. Click at the start of the first paragraph of the wide content and choose Layout › Breaks › Next Page (under Section Breaks).
  2. Click at the start of the paragraph after the wide content and insert another Next Page section break.
  3. Click in the middle section and choose Layout › Orientation › Landscape; it applies to that section only.
  4. To remove a break, turn on Show/Hide ¶, select the “Section Break (Next Page)” marker and press Delete, then check Layout › Orientation and Margins.

In the Word Exercises browser editor

  1. Click at the start of the first paragraph of the wide content and choose Section break › Next page; the break is inserted before that paragraph.
  2. Click at the start of the paragraph after the wide content and insert another Next page break.
  3. Click in the middle section, open Page setup…, choose Landscape, keep Apply to: This section, then Apply.
  4. To remove a break, click the dashed “Section break” line to select it and press Delete, then check the remaining section in Page setup….

Menu names follow the Microsoft 365 ribbon as of 2026; older versions may label commands differently.

Common mistakes

  • Using a page break when the page setup must change.
  • Turning the whole document landscape for one wide table.
  • Deleting a section break without checking the settings the text above has inherited.

Practise

Take the module 7 quiz

Guides on this topic

Last reviewed 2026-11-04. Word Exercises is independent and not affiliated with Microsoft.